Good news........... sudah ada update driver terbaru
visit the link..............
http://www.driverheaven.net/mac-os-x...ased-beta.html
1.1b1 (BETA) version is finally out.
Changes:
* Fixed noise for 10k1 based cards
Features:
* 16-bit or 24-bit playback on most 10k1/10k2 cards (depending on card model)
* supports up to 8 speakers (configure speaker configuration in OS X 'Audio and MIDI' panel)
* should support SPDIF and headphones outputs, if applicable
* supports external modules (LiveDrive)
* supports hardware volume control and mute
Unimplemented:
* recording
* SPDIF/AC-3 passthrough
* 16/24-bit recording
* kX DSP and routing, no custom DSP effects, SDK and API
* hot-plug for PCMCIA device (Audigy2 ZS notebook) - surprise removal will probably cause a lock-up or kernel panic
* any sampling rate except 48000Hz not supported, OS X uses built-in SRC, which is quite good
Known issues:
* E-mu E-DSP cards are supported, but their FPGA firmware is not uploaded by default. If you are using Hackintosh, you will need to install kX driver, ensure audio is OK and reboot into OS X, this way FPGA firmware will be preserved and you will get audio.
* When installing under Leopard, you may need to reboot after you run the installer, because leopard won't load driver KEXT file, or reload the KEXT by using 'sudo kextload -t' command.
udah gak sabar mau coba.......... hehehehehe
kalau di baca dari dari forum bugsnya........ distorsi tidak ditemukan lagi pada beberapa tipe sound cardnya termasuk audigy, untuk soundblaster live value (C500), masih ditemukan distorsi...........
layak di coba bagi pemilik soundcard creative..........
Multi channel di OS X ??? bukan mimpi lagi.......... hehehehe
di tunggu laporannya bagi yang udah coba.
thanks......![]()




Reply With Quote


?





Bookmarks